Better from experience

Our longstanding partnership with Bosch-Rexroth has resulted in several pioneering innovations which make your system technology fit for the future:

HMC
The Hydraulic Motion Controller (HMC) sets new standards in the modern automation of hydraulic drives for up to 2 axes:

• Straightforward, open and scaled digital axis control
• Digital axis controllers for one or two electrohydraulic axes
• Flawless function for position, pressure, force, speed and release control (position/pressure or force)
• Intelligent communication: Sercos, PROFINET RT, EtherCAT, EtherNET/IP, POWERLINK, optional PROFIBUS, analogue
• Parameterisable with standard Ethernet

HNC 100
This “all-rounder” sets standards in hydraulic drive control. Due to its exceptional range of interfaces and free programmability, it fulfils a wide range of requirements and can be integrated on a flexible basis into any control architecture without any problems.

• For controlling 1 to 4 axes
• NC programming
• WinPed 7 operating software
• CE conformity according to EMC Directive 2004/108/EC
• Freely configurable controller versions...
  ... Position control
  ... Force control
  ... Pressure control
  ... Release position/pressure or position/force control
  ... Speed control
  ... Path-dependent braking
  ... Synchronisation (master/slave or average value principle)
• Bus connection (Sercos, PROFINET RT, EtherNet/IP)
• Actual value acquisition...
  ... Position encoder: incremental
  ... Position encoder: absolute (SSI)
  ... Analogue 0 to ±10 V and 0(4) to 20 mA
• Correcting variable output: voltage or current
• Service interface: RS232, optional TCP/IP